four way traffic signal Model T6 - Four Way Traffic Light Control

The T6 - 4 Way Traffic Signal Control, will operate a 4 direction, 3 color traffic light. The 6 discrete output channels will synchronize 2, 3 or 4 directions of signal heads.

If you already have a 3 light, 4 way signal you are in luck since we have just added the T6 , a full 4 way signal control to our product lineup, This control will simulate the big cabinet models while it is only 3x3 inches and fits easily inside the case of most lights.

4 Way lights not only look great on display they are also very collectable, trading from $600 and up on the open market.  Until now one would have to buy a cabinet full of expensive electronics just to make one of these signals operate properly.  Now we have a very nice, compact control that will make one of these lights cycle like it should.

If you dont have a four way signal light this control can also operate 2 or 3 way light configurations (ie. 2 or 3, G-Y-R signal heads) set up to control opposing traffic directions.

Another great use is where you have two G-Y-R signal heads on a pole facing 90 degrees apart, this is true 2 Way operation.   These look great in the corner of a room.

T6 4-way signal control

                        The T6 features:

A single control board 3 x 3 in.

Kit comes with 4 self-adhesive nylon mounting posts so 
no drilling is required to install.

    Socket mounted, 8 bit micro-controller

    Adjustable cycle speed control from less than ten seconds to 
    over a minute per cycle.

    Six - 120 VAC Triac output channels each capable of 
    150W max. incandescent load

    Flash Mode jumper that will cause all four directions to flash in either of
    two modes; 4 Way- ALL RED flash or Red / Yellow alternate flash mode.

    Operated directly from 120V AC line no external Power supply required.

    Dual 4 position screw terminal strip for easy (AC) light connections.

    Switch selectable Red light overlap delay of either 0 or 2 second.

    Flash Mode Input forces the control into a flashing mode

    Will operate 2,3 or 4, Std 3 light signal heads. (A-B, A-A'-B, A-A'-B-B')

                 This is 2, 3 or full 4 directions of traffic control.

 

The on board switch selects Flash Mode and Red Overlap Time Red light overlap time is either 0 or 2 second. Flash Mode causes all four directions to flash in either of two modes; Flash Mode type selection lets you chose between 4 Way- ALL RED flash or 2 Red / 2 Yellow alternate flash mode.

There is a simple to use, speed adjustment that controls the speed of the cycle. All color phase timing is adjusted dynamically so the cycle is realistic.
 

   Simple to install:

 T6  Wiring Diagram

 

Lights to Go!
Price List & Order Form

OR
Order Online with your Credit Card

For questions or comments Email: Lights to Go! 



Home Page

(C) Lights To Go! 2005 -2011