The P10 - 4 Way Traffic Signal Control, will not only operate a 4way traffic light, it will control a whole simulated intersection in your home or business.

If you a 4 way signal or even 2 or more 3 light signal heads and want to control two Walk / Dont Walk lights with a single,  simple low cost control your in luck.  The P10 has been a special order item only untill now we are stocking it as a standard product.

The P10  includes the functionallity of the (Model P6)  4 way signal control synchronized with two (Model P2) Walk/ Dont Walk Pedstrian light controls.   This control will simulate the big cabinet mounted models while it is only 4x4 inches and fits easily inside the case of your light or in a simple 6x6 external control box (optional).       The power supply is even integrated on the board so you dont have to deal with an external AC adaptor.

4 Way lights not only look great on display they are also very collectable, trading from $600 and up on the open market.  Until now one would have to buy a cabinet full of expensive electronics just to make one of these signals operate.  Now we have a very nice, compact control that will make one of these lights cycle like it should.

If you dont have a four way signal light this control can also operate 2 or 3 way light configurations (ie. 2 or 3, G-Y-R signal heads) set up to control opposing traffic directions.
You can even operate 2 Walk lights on the same Pole for even greater realism.

Another great use is if you have two G-Y-R signal heads on a pole facing 90 degrees apart, this is true 2 Way operation.    These look great in the corner of a room.  Of course you can have PEDESTRIAN SIGNALS synchronized to the signals. All outputs do not have to be used. You can just hook up what you have now and add additional signals in the future.
 

• A single control board 4 x 4 in.
• 4 x 0.140 in. mounting holes on 3.5 x 3.5 ctrs.
• Integrated on-board power supply
• On Board Fuse protection
• Socket mounted, 8 bit microcontroller
• Digital cycle speed adjustment, w/ 4 preprogrammed time set selections.
• 10 - 120 V Triac output channels each capable of 150W max. incandescent load
• All 10 output channels opto-isolated from the remainder of control.
• 10 colored LEDs on board to monitor the logic state of each output channel
• Dual 4 position screw terminal strip plugs for (AC) light connections.
• Separate 5 position screw term connector for Walk Lights
• Flash Mode Input forces the Signals control into a flashing mode
• Will operate 2,3 or 4, Std 3 light signal heads. (A-B, A-A'-B, A-A'-B-B')
            This is 2, 3 or full 4 directions of traffic control.

Price:  Commercial Model     $135.00
             Industrial Model           $245.00  ea.
 

Hookup is very easy.   See our Installation WIRING DIAGRAM.

See our ANIMATED GIF for an (accelerated) sequence simulation

There are two switches on the board that are used to set the timing modes.   This gives you four different sets of timing values you can choose between.  The standard timings are as follows:
 

Mode	Green A	Green B	Yel Time
Mode 1	10sec	10sec	4sec
Mode 2	15sec	15sec	4sec
Mode 3	20sec	20sec	5sec
Mode 4	25sec	25sec	5sec

Custom modes are also available for a additional charge.
Send us an Email with your desired timings and we'll send you a quote.

Lights to Go!
Price List & Order Form
OR
Order Online with your Credit Card

For questions or comments Email: Lights to Go! 


---



Home Page
Lights to Go!

(C) Lights To Go! 2000     Revised 08/15/00